Red Floral Border Trim

About This Design

This flower border design stitches out at 83.0 × 51.0 mm (3.3 × 2.0 in) and uses 6 thread colors across 5 color changes. Total count is 2,084 stitches at a density of about 49.2 stitches/cm².

At The Machine

• Estimated stitch-out time: ~3 minutes at 600 spm
• Color changes: 5
• Follow the color sequence table above — thread numbers refer to the chart programmed in the file; match them to your brand by color.

Fabric & Hooping

At about 49.2 stitches/cm² this is an open, low-density fill, so it sits happily on quilting cotton, linen or lightweight shirting with a single layer of tear-away behind it. At 83.0 × 51.0 mm a 4×4 in hoop is plenty.

Thread Colors in This Design

DST files store stitch data but no thread information, so the colors below are our suggested DMC match. Swap in whatever you have in a similar shade:

• 3746 Dark Blue Violet
• 704 Bright Chartreuse
• 815 Medium Garnet
• 550 Very Dark Violet
• 909 Very Dark Emerald
• 899 Medium Rose

Stitching Notes

With 6 colors and 5 changes you can pre-wind the whole set before you start and never leave the machine. DST stores stitch data only, which is why the color list is a suggestion rather than the digitizer's original choice.

What to Make With It

A border repeats well along table runners, pillowcase edges, curtain hems and quilt sashing. Stitch one repeat on scrap and measure it, then work out how many repeats your piece needs before you hoop the real fabric.