Fine Dot Line Border

About This Design

This border design stitches out at 514.6 × 28.2 mm (20.3 × 1.1 in) and uses 10 thread colors across 10 color changes. Total count is 3,121 stitches at a density of about 21.5 stitches/cm².

At The Machine

• Estimated stitch-out time: ~5 minutes at 600 spm
• Color changes: 10, automatic trims: 1
• Follow the color sequence table above — thread numbers refer to the chart programmed in the file; match them to your brand by color.

Fabric & Hooping

At about 21.5 stitches/cm² this is an open, low-density fill, so it sits happily on quilting cotton, linen or lightweight shirting with a single layer of tear-away behind it. At 514.6 × 28.2 mm this needs a large-format hoop, or splitting across several hoopings with alignment marks — check it against your machine's maximum field first.

Thread Colors in This Design

DST files store stitch data but no thread information, so the colors below are our suggested DMC match. Swap in whatever you have in a similar shade:

• 798 Dark Delft Blue
• 208 Very Dark Lavender
• 780 Ultra Very Dark Topaz
• 415 Pearl Gray
• 815 Medium Garnet
• 3716 Very Light Dusty Rose
• 743 Medium Yellow
• 702 Kelly Green
• 958 Dark Sea Green
• 820 Very Dark Royal Blue

Stitching Notes

10 colors across 10 changes makes this a real thread-management job: lay the spools out in sequence order first and keep the color chart to hand. DST stores stitch data only, which is why the color list is a suggestion rather than the digitizer's original choice.

What to Make With It

A border repeats well along table runners, pillowcase edges, curtain hems and quilt sashing. Stitch one repeat on scrap and measure it, then work out how many repeats your piece needs before you hoop the real fabric.